Minor - A 2-byte decimal unit identifier for your beacon.Major - A 2-byte decimal group identifier for your beacon. UUID - A 16-byte hexadecimal organizational identifier for your beacon.In this section, specific the following values With the iBeacon or AltBeacon advertisement type enabled, you can make changes to the iBeacon and AltBeacon advertised values under the section labeled IBEACON/ALTBEACON. Setting the iBeacon and AltBeacon Advertisement Values Select the beacon proximity advertisement types that you want to have transmitted by this beacon device and apply your changes along with a valid PIN. Changing the Beacon Advertisement Typeįrom the beacon detail settings view, under Type, you will find a set of switches for each beacon advertisement type, including You can change the beacon name by modifying the string value in the beacon text input field and applying your changes along with a valid PIN. The beacon name is not transmitted as part of the proximity beacon advertisements and is only readable when the beacon is in configuration mode by a valid configuration tool like the RadBeacon configuration app. The beacon name is a simple string value that exists as a convenience for recognizing the beacon when you attempt to configure it in the future. It is highly recommended to update your PIN to ensure that only authorized individuals may make changes to your beacon's configuration Changing the Beacon Name For beacon models and versions that support an eight (8) digit PIN, the default PIN is '00000000'. įor beacon models and versions that support a four (4) digit PIN, the default PIN is '0000'. You may change any or all of the modifiable settings, press Apply, and submit a valid PIN to update the settings for the RadBeacon. Once you've selected a beacon from the list of nearby configurable beacons, you will be shown the detailed Settings view. I have an bare-bones app you can run on Android to do this here, but you'll need a copy of Android Studio to build and run it.Update Table of Contents Changing the Beacon Name Changing the Beacon Advertisement Type Setting the iBeacon and AltBeacon Advertisement Values Setting the Eddystone UID Advertisement Values Setting the Eddystone URL Advertisement Values Modifying the Advertising Rate Modifying the Transmit Power Level Applying Your Changes Locking Your Settings Restoring Your Beacon to Factory Settings If the above two suggestions don't help, I would use an independent tool such as an Android phone to actually count the number of BLE packets detected. Bring your transmitter and receiver closer together.Having the weakest power output configured is the most likely cause of your issue. Increase your transmitter power level from -18 dBm to 3 dBm.Since your detection rate is much lower, you may want to try a number of things: Under good conditions (close range, high transmitter power), I typically see 80-90% of packets get detected by Android and iOS devices which allow you to easily count individual BLE packets. Antennas on both transmitter and receiver.The actual percentage received depends on a number of factors including: Not 100% of advertising packets send out by a Bluetooth LE device will be detected by receiving devices.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |